Easyscriber engrave attachment for Hypertherm torch's
 

kerf?

Information on plasma cutting nozzles, electrodes, and other consumables.
Post Reply
kbenz
Posts: 424
Joined: Sun Oct 31, 2010 1:26 pm
Location: Kannapolis,NC
Contact:

kerf?

Post by kbenz » Tue Oct 18, 2011 5:30 pm

what should the kerf be set at for fine cut consumables?

kbenz
Posts: 424
Joined: Sun Oct 31, 2010 1:26 pm
Location: Kannapolis,NC
Contact:

Re: kerf?

Post by kbenz » Tue Oct 18, 2011 5:59 pm

on 1/8" material

rottenleonard
Posts: 34
Joined: Sun Nov 20, 2011 10:30 am

Re: kerf?

Post by rottenleonard » Thu Jan 19, 2012 10:50 am

Make a short cut and use digital calipers to measure how wide the cut is then input that measurement as the kerf width.
Hope that helps.

Dawgonhawg
Posts: 484
Joined: Sun Mar 27, 2011 10:13 pm

Re: kerf?

Post by Dawgonhawg » Mon Oct 22, 2012 2:16 pm

.027 is what I use..

Dawg

Post Reply