Easyscriber engrave attachment for Hypertherm torch's
 

Muriatic Acid consentration

Learn and share dross removal techniques, experiences, and product knowledge here.
Post Reply
User avatar
little blue choo
Elite Contributing Member
Elite Contributing Member
Posts: 1457
Joined: Mon Mar 02, 2015 10:38 pm
Location: Cherryville NC
Contact:

Muriatic Acid consentration

Post by little blue choo » Tue Sep 22, 2015 9:04 pm

What concentration of muriatic acid do you use to remove dross.

Thanks
Rick
Rick
Arclight 9600 4x8 table
Hypertherm PM65
Acc. Plate Marker, 4 inch Pipe Cutter, Wood Router package
Quincy Q54 compressor 2 stage, 5hp, 60 gal
Refrigerated air dryer & 4 stage filtration system
Software Mach 3, Sheetcam, Solid Edge 2D, Inkscape

Masons Forge
Posts: 80
Joined: Fri Jul 05, 2013 11:18 pm
Location: Concord NC
Contact:

Re: Muriatic Acid consentration

Post by Masons Forge » Tue Sep 22, 2015 9:43 pm

I use 1:1.5 to 1:2 acid to water. This is just an estimate. I don't measure

User avatar
little blue choo
Elite Contributing Member
Elite Contributing Member
Posts: 1457
Joined: Mon Mar 02, 2015 10:38 pm
Location: Cherryville NC
Contact:

Re: Muriatic Acid consentration

Post by little blue choo » Tue Sep 22, 2015 11:19 pm

What I was looking at was like 32% or something like that. So you then cut the 32% stuff 1 part acid to 1.5 part water. Is this right?

Thanks
Rick
Rick
Arclight 9600 4x8 table
Hypertherm PM65
Acc. Plate Marker, 4 inch Pipe Cutter, Wood Router package
Quincy Q54 compressor 2 stage, 5hp, 60 gal
Refrigerated air dryer & 4 stage filtration system
Software Mach 3, Sheetcam, Solid Edge 2D, Inkscape

Post Reply