Cloudy haze upon rinse

Learn and share patina finishing techniques, experiences, and product knowledge here.
Post Reply
JulietteInc
Posts: 4
Joined: Mon Aug 05, 2019 6:05 pm

Cloudy haze upon rinse

Post by JulietteInc » Mon Dec 02, 2019 7:33 pm

Hi, I recently purchased a starter kit of patinas, I'm trying to make the most of my husbands new plasma table! Anyway, I tried my first patinas this weekend and I'm not sure what I did wrong but all that I tried ended up with a cloudy sort of haze on them almost immediately after rinsing. I don't know if it matters but we are on well water and the temperatures were pretty cold. I'm sure its operator error but I'm not sure how to fix it. Any suggestions would be greatly appreciated.

User avatar
steelfx
Elite Contributing Member
Elite Contributing Member
Posts: 766
Joined: Sat Oct 10, 2009 12:09 am
Location: St. George, Utah
Contact:

Re: Cloudy haze upon rinse

Post by steelfx » Sat Jan 18, 2020 12:13 am

A haze only occurs on a couple of the patinas. All you need to do is wipe it off with a damp paper towel, then dry and clear-coat.
Bill

Post Reply

Return to “Patina Finishes”

Easyscriber engrave attachment for Hypertherm plasma cutters.