All kinds of FUBAR going on. New Guy needs help

Inkscape related questions and tips can be posted to this topic.
Post Reply
mkingaz
Posts: 34
Joined: Wed Jun 05, 2019 7:32 pm
Location: Glendale Arizona

All kinds of FUBAR going on. New Guy needs help

Post by mkingaz » Tue Oct 01, 2019 7:23 pm

Hi everyone,

I have been trying to build this project for about 2 weeks now and just cannot get it drawn up correctly to save my life. Figured it might be time to ask for help. I was trying to union the entire piece and then tried to cut the center out and I was going to layer it on top of plexi-glass and glue it back into place. It would be night to keep it all as one if possible. I was doing a duplicate backing sheet with it.

Can anyone help be get this correct?
MIKEJODYCIRCLE.dxf

You do not have access to view or download this file.
Become a Contributing Member to gain access to this feature. Click Here


User avatar
acourtjester
Elite Contributing Member
Elite Contributing Member
Posts: 3954
Joined: Sat Jun 02, 2012 6:04 pm
Location: Pensacola, Fla

Re: All kinds of FUBAR going on. New Guy needs help

Post by acourtjester » Tue Oct 01, 2019 10:41 pm

I looked it over and you have hundreds of short lines and curves that is not way you can do what you want with this drawing.
I would suggest you contact Ben Delap to have him draw a new file.
www.etsy.com/shop/DesignsByDeLap https://www.facebook.com/designs.by.delap
partsAAA.JPG

You do not have access to view or download this file.
Become a Contributing Member to gain access to this feature. Click Here

DIY 4X4 Plasma/Router Table
CandCNC DTHC-IV & Feather Touch
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PM 256 tig

ctgolfer1
Elite Contributing Member
Elite Contributing Member
Posts: 53
Joined: Thu May 30, 2019 4:35 pm

Re: All kinds of FUBAR going on. New Guy needs help

Post by ctgolfer1 » Wed Oct 02, 2019 6:45 am

mkingaz wrote:
Tue Oct 01, 2019 7:23 pm
Hi everyone,

I have been trying to build this project for about 2 weeks now and just cannot get it drawn up correctly to save my life. Figured it might be time to ask for help. I was trying to union the entire piece and then tried to cut the center out and I was going to layer it on top of plexi-glass and glue it back into place. It would be night to keep it all as one if possible. I was doing a duplicate backing sheet with it.

Can anyone help be get this correct?MIKEJODYCIRCLE.dxf
Hey man, I have to totally agree with the above poster, there is way too much going on in there to cut it on plasma, Ben Delap will clean that up and return it to you in a clean file that can be cut. Ben has done a some work for me and it most likely the only way your going to get this cut, he does not charge very much.
Good luck!

mkingaz
Posts: 34
Joined: Wed Jun 05, 2019 7:32 pm
Location: Glendale Arizona

Re: All kinds of FUBAR going on. New Guy needs help

Post by mkingaz » Wed Oct 02, 2019 11:38 am

Thank you both for the input. Much appreciated.

Post Reply

Return to “Inkscape”

Easyscriber engrave attachment for Hypertherm plasma cutters.