Easyscriber engrave attachment for Hypertherm torch's
 

Lost the arc transfer input

Thermal Dynamics plasma cutter discussion forum.
Post Reply
Hokwood
Posts: 1
Joined: Tue Jun 28, 2016 7:42 pm

Lost the arc transfer input

Post by Hokwood » Thu Sep 21, 2017 8:37 pm

Hello all
I am new to this and dont know where to start to fix it. I have a dynatorch 4x8 with a a-60 cutter. I keep getting this message and it stopping motors,
then i have to start all over, message is same as subject lost arc transfer input. does anyone know where to start to fix this
Thanks
Hokwood

Post Reply