Firepower plasma cutter

Thermal Dynamics plasma cutter discussion forum.
Post Reply
Giger1039
1 Star Member
1 Star Member
Posts: 17
Joined: Wed Feb 08, 2017 10:04 pm

Firepower plasma cutter

Post by Giger1039 »

Hey guys not sure if this in the right spot...have never posted before. I got a firepower fp35a plasma cutter for next to nothing. Its like brand new. Is it possible to use this machine on a DIY table? It would be used for light gauge artwork. I have purchased plans to make a table and I am fairly competent in fabrication and wiring, although I know nothing about cnc at all. I don't believe it has a cnc port. Thanks in advance to your replies.
Dana gear
2 Star Member
2 Star Member
Posts: 54
Joined: Fri Jan 13, 2017 10:55 pm

Re: Firepower plasma cutter

Post by Dana gear »

I am assuming that your Fire power is a Thermal Dynamics product, I am pretty sure there is no CNC interface on the model 35.
This does not mean that it cannot be done, you may want to call the tech guys over at Thermal Dynamics 1-866-279-2628.
Post Reply

Return to “Thermal Dynamics / Esab Plasma Cutters”