Easyscriber engrave attachment for Hypertherm torch's
 

Firepower plasma cutter

Thermal Dynamics plasma cutter discussion forum.
Post Reply
Giger1039
Posts: 1
Joined: Wed Feb 08, 2017 10:04 pm

Firepower plasma cutter

Post by Giger1039 » Wed Feb 15, 2017 10:40 pm

Hey guys not sure if this in the right spot...have never posted before. I got a firepower fp35a plasma cutter for next to nothing. Its like brand new. Is it possible to use this machine on a DIY table? It would be used for light gauge artwork. I have purchased plans to make a table and I am fairly competent in fabrication and wiring, although I know nothing about cnc at all. I don't believe it has a cnc port. Thanks in advance to your replies.

Dana gear
Posts: 54
Joined: Fri Jan 13, 2017 10:55 pm

Re: Firepower plasma cutter

Post by Dana gear » Mon Apr 03, 2017 5:44 pm

I am assuming that your Fire power is a Thermal Dynamics product, I am pretty sure there is no CNC interface on the model 35.
This does not mean that it cannot be done, you may want to call the tech guys over at Thermal Dynamics 1-866-279-2628.

Post Reply