It is currently Sat Nov 17, 2018 6:42 pm


Thermal Dynamics a60 - PlasmaCam

Thermal Dynamics plasma cutter discussion forum.
Posts: 1
Joined: Tue Feb 16, 2016 1:27 am

Thermal Dynamics a60 - PlasmaCam

Postby Roaddog908 » Mon Mar 14, 2016 10:54 pm

i'm trying to put a new a60 on my plasma cam table but i'm not getting a arc signal back for travel any know how to wire these

Posts: 6
Joined: Wed Mar 16, 2016 11:17 pm

Re: Thermal Dynamics a60 - PlasmaCam

Postby bpr » Fri Jun 17, 2016 5:54 pm

Did you figure it out, I am having the same problem right now with an A120.

Return to “Thermal Dynamics Plasma Cutters”

Who is online

Users browsing this forum: No registered users and 1 guest

Easyscriber engrave attachment for Hypertherm torch's