Page 1 of 1

Cutmaster 82 arc ok and touch switch help

Posted: Tue Jul 16, 2013 8:39 pm
by Little Leonard
I'm building a plasma table and I'm installing candcnc DTHC in my cutmaster 82, I need to know where the arc ok wires are and the touch switch is. I'm installing there Voltage divider card, THC SENSOR MODULE and there Digital Current Probe any help would be great

Re: Cutmaster 82 arc ok and touch switch help

Posted: Wed Jul 17, 2013 8:58 am
by mlinehan
Here are directions for the connections you want to make.

Short version: OK to Move is on connector J10, pins 1 & 3.
Arc voltage is on -V Out 1 and Work 1.
Start /Stop is on J10, pins 6 & 8.

You can see these connections drawn in the schematic at the rear of your owner's manual.

Re: Cutmaster 82 arc ok and touch switch help

Posted: Wed Jul 17, 2013 4:28 pm
by Little Leonard
Thanks ill give it a try I've looked everywhere for this info