Cutmaster 82 arc ok and touch switch help
-
- Posts: 37
- Joined: Sun Jul 14, 2013 1:08 pm
- Contact:
Cutmaster 82 arc ok and touch switch help
I'm building a plasma table and I'm installing candcnc DTHC in my cutmaster 82, I need to know where the arc ok wires are and the touch switch is. I'm installing there Voltage divider card, THC SENSOR MODULE and there Digital Current Probe any help would be great
Re: Cutmaster 82 arc ok and touch switch help
Here are directions for the connections you want to make.
Short version: OK to Move is on connector J10, pins 1 & 3.
Arc voltage is on -V Out 1 and Work 1.
Start /Stop is on J10, pins 6 & 8.
You can see these connections drawn in the schematic at the rear of your owner's manual.
Short version: OK to Move is on connector J10, pins 1 & 3.
Arc voltage is on -V Out 1 and Work 1.
Start /Stop is on J10, pins 6 & 8.
You can see these connections drawn in the schematic at the rear of your owner's manual.
- Attachments
-
- Arc Voltage Instructions.pdf
- (916.74 KiB) Downloaded 37 times
-
- Posts: 37
- Joined: Sun Jul 14, 2013 1:08 pm
- Contact:
Re: Cutmaster 82 arc ok and touch switch help
Thanks ill give it a try I've looked everywhere for this info
Who is online
Users browsing this forum: Google [Bot] and 3 guests