Maverick CNC with easy scriber not working

Don't see your table manufacturer listed above? Post here in this forum.
Post Reply
FitmentFab
1/2 Star Member
1/2 Star Member
Posts: 1
Joined: Thu Sep 30, 2021 12:40 am

Maverick CNC with easy scriber not working

Post by FitmentFab »

Hello all,

I just got my easy scriber and I am running a maverick MV510 but I cannot get it to run. I keep getting the error code m100/101.

I believe this is because the marking fab head option in this software is for their pneumatic scriber that runs off of the air supply for the plasma power source.

any advice would be appreciated.

-cody
User avatar
acourtjester
6 Star Elite Contributing Member
6 Star Elite Contributing Member
Posts: 7770
Joined: Sat Jun 02, 2012 6:04 pm
Location: Pensacola, Fla

Re: Maverick CNC with easy scriber not working

Post by acourtjester »

If you can run G-codes generated by SheetCam just use a generic post processor using a router protocol with a shallow cut depth. I use that for drag knife cutting, metal scribe, Plotter pen and engraving operations. Just don't exceed the easy scribe spring preload.

DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT
weldguy
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1929
Joined: Fri Apr 17, 2009 11:48 am

Re: Maverick CNC with easy scriber not working

Post by weldguy »

I'm with AC, a different post processor is likely all you need. Just try the post you use for plasma cutting and let us know what happens.
Post Reply

Return to “Various Manufacturers Forum”