Easyscriber engrave attachment for Hypertherm torch's

Another table advice thread

Have a question and don't see your manufacturer? Post here and if we get enough action on that manufacturer we will add a forum
Post Reply
Posts: 5
Joined: Fri Jun 29, 2018 10:36 pm

Another table advice thread

Post by Jimmy707v » Wed Oct 10, 2018 5:17 pm

I am looking at several different plasma tables. I am looking at light commercial to commercial tables and don't see much chatter about them. I have checked into Shopsabre, Fastcut cnc, Ez cut CNC and Messer. I am wanting a 5x10 table but I do not have 3 phase in the shop so I am very limited. Hypertherm 85 is the max. I am looking for a robust table that will last a long time and be accurate. I mostly will be cutting steel and stainless parts from 14 gage to 1/2 thick. Very little art. I know messer and shopsabre are on the high end with the other two close behind them. I know these are not cheap but I do not want to fight a cheap table for years to come. Any suggestions on these 4? Are there any other comparable tables I am missing. Any help would be appreciated.

Elite Contributing Member
Elite Contributing Member
Posts: 503
Joined: Thu Nov 19, 2015 10:02 pm

Re: Another table advice thread

Post by djreiswig » Thu Oct 11, 2018 9:58 pm

2014 Bulltear (StarLab) 4x8
C&CNC EtherCut
Mach3, SheetCam, Draftsight
Hypertherm PM65
Oxy/Acetylene Flame Torch
Pneumatic Plate Marker, Ohmic, 10 inch Rotary Chuck (in progress)

Post Reply

Return to “Various Manufacturers”