Page 1 of 1

Ezcut stalled.

Posted: Sun Apr 01, 2018 7:41 pm
by Voesenekcnc
Machine sparks up and won’t move on to cut pattern. Just blows hole. Help?

Re: Ezcut stalled.

Posted: Mon Apr 02, 2018 8:51 pm
by Voesenekcnc
Voesenekcnc wrote:Machine sparks up and won’t move on to cut pattern. Just blows hole. Help?
has anyone had this problem or know what we can do to fix it ??

Re: Ezcut stalled.

Posted: Tue Apr 03, 2018 4:45 am
by larrycameron44
I think to answer your question we need more info.
Machine
Plasma cutter
Software
Settings etc

Larry Cameron
RusticMetalArt

Re: Ezcut stalled.

Posted: Fri Apr 13, 2018 11:57 pm
by waldner33
Yes the small board where the powmax or plasma cutter plugs in has 2 small relays on it replace board .
It dosnt get the ok to move signal

Re: Ezcut stalled.

Posted: Fri Apr 13, 2018 11:58 pm
by waldner33
On the control of the machine not the cutting unit