Just chasing some info on this product, we have a Pro Plas 1530 CNC cutting machine with an 85 Amp Hypertherm cutting system with a Starfire controller 2300, we are cutting a lot of perforated panels and need to change the height that the torch goes up and down to the next hole as these are only 7mm dia and there are 225 holes per plate in 1mm Zincanneal, at the moment it goes up about 60mm and then comes down to pierce and cut the next hole we want to change this to be about 10mm till it traversers to the next hole and this will cut out time down significantly.
There is nothing in the manual about this can anyone please help
It is currently Wed Nov 14, 2018 5:23 pm
Have a question and don't see your manufacturer? Post here and if we get enough action on that manufacturer we will add a forum
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest