Easyscriber engrave attachment for Hypertherm torch's

Anyone heard of MFM industrial ?

Have a question and don't see your manufacturer? Post here and if we get enough action on that manufacturer we will add a forum
Post Reply
Posts: 1
Joined: Wed Feb 21, 2018 2:59 pm

Anyone heard of MFM industrial ?

Post by Grovefabworks » Wed Feb 21, 2018 3:10 pm

Hey guys, new here and to the world of CNC plasma. But reading a lot on this forum has helped me get a better grasp in what I'm looking for.

But has anyone dealt with MFM Industrial??

They are located about an hour from me so I will be going by there at some point, but from what I can tell they seem to be well built tables.
A 4x8 table with water table, computer, sheetcam, mach3, ect. everything included minus the plasma is $10,000.

whatcha gentlemen think?

Posts: 3
Joined: Thu Apr 27, 2017 10:21 pm

Re: Anyone heard of MFM industrial ?

Post by bnflette » Mon May 07, 2018 3:43 am

I bought a table from them but did not receive a shred of documentation as was promised and very little support.

User avatar
little blue choo
Elite Contributing Member
Elite Contributing Member
Posts: 1457
Joined: Mon Mar 02, 2015 10:38 pm
Location: Cherryville NC

Re: Anyone heard of MFM industrial ?

Post by little blue choo » Mon May 07, 2018 11:23 am

Enough said. Thanks bnfette.

Arclight 9600 4x8 table
Hypertherm PM65
Acc. Plate Marker, 4 inch Pipe Cutter, Wood Router package
Quincy Q54 compressor 2 stage, 5hp, 60 gal
Refrigerated air dryer & 4 stage filtration system
Software Mach 3, Sheetcam, Solid Edge 2D, Inkscape

Fred V
Posts: 4
Joined: Tue Jun 12, 2018 12:49 pm

Re: Anyone heard of MFM industrial ?

Post by Fred V » Tue Jun 12, 2018 1:17 pm

I am in California too and found MFM Industrial. Did you purchase a table from them?
Anybody else has any experience working with them?
Any help would be greatly appreciated.

Post Reply