Part numbers for TM1 motor pulleys

Post by **kbenz** » Thu Apr 18, 2013 2:43 pm

any idea what the grainger part number's are for the motor pully's on the TM1? or the specs?

Gamelord · Post by **Gamelord** » Thu Apr 18, 2013 10:29 pm

Get with Torchmate directly and they can get you taken care of. What parts do you need? I may have some laying around that I don't use anymore. I upgraded to the geared transmission drives and got rid of the belts.

Post by **kbenz** » Fri Apr 19, 2013 8:27 am

Gamelord wrote:Get with Torchmate directly and they can get you taken care of. What parts do you need? I may have some laying around that I don't use anymore. I upgraded to the geared transmission drives and got rid of the belts.

looking for the two pully's on top and the belt. I am not a big fan of torchmate service right now. I can get the same parts quicker and the RIGHT parts from grainger. I had a list at one time but cannot find it

Post by **kbenz** » Mon Apr 22, 2013 8:14 am

anyone?

SignTorch Vector Art · Mon Apr 22, 2013 5:35 pm

It's hard to tell for sure but that's probably a standard MXL series (.08" pitch)

between comparing tooth count and od with various pulley specs, it should be easy to pick the right one

you can determine the pitch by measuring the belt, for MXL ten teeth would measure .8"

then you just have to match the belt width and bore, beyond that you don't really have to use components with that same pitch (if it's not MXL you could retrofit with all MXL components), as long as the tooth ratio is the same

sdp-si.com has a nice searchable catalog

Part numbers for TM1 motor pulleys

Part numbers for TM1 motor pulleys

Re: part numbers

Re: part numbers

Re: part numbers

Re: part numbers