Torchmate Hypertherm Powermax 45 AVHC-no cnc interface cable

[larrycameron44]

Got my system and after a few hiccups its up and running. Well sort of.
Had a wee problem with the cnc interface cable.... it wasn't supplied. You need this, so I had to make up one.
No binding issues at present, jogs in high speed etc.
Ran the test line speed file. Voltage file etc. I can only think that with some more fine tuning on my behalf it should be groovy and I shall not have to hand cut templates any more . Yay
Youtube of the system doing a dry run as I have yet to fill the water table

http://www.youtube.com/watch?v=jnOPLtwvlgk
Please let me know if you have any ideas where to put the bloody wires for the motors
Cheers

Larry
NZ

[wishiwastorching]

Welcome to the Torchmate club!!! I too have a 2x4 and Pmax 45. Though I have mine on saw horses at the moment while I build a custom water table big enough to house TM's new 4ft gantry upgrade. I love mine and can't wait for my table. Good luck!!!

[larrycameron44]

Thanks mate, its the bees knees!