It is currently Thu Nov 15, 2018 12:00 pm

 

Help with upsidedown cutting with Torchmate

Torchmate Hardware discussion forum
User avatar
tentonjj
Elite Contributing Member
Elite Contributing Member
Posts: 221
Joined: Fri Nov 14, 2008 8:57 pm

Help with upsidedown cutting with Torchmate

Postby tentonjj » Wed Jul 15, 2009 7:00 pm

Helo all, I've been here for a little while and found some useful info on here. I have an issue with our torchmate software. When I load it into Torchmate 3 to cut the steel, it always cuts it upside down on the plasma table leaving large slag on the feature side of the piece. I hate using the grider cause it leaves such deep grooves. If I reverse the drawing the same thing happens. Any advice would be great!!!!
Jayson Johnson
JMJ Graphix
920-517-7122

jim
Elite Contributing Member
Elite Contributing Member
Posts: 67
Joined: Thu Jun 25, 2009 7:48 am

Re: Help with upsidedown cutting with Torchmate

Postby jim » Sat Jul 18, 2009 8:29 am

For my software i use coral draw and then send it to comand and cut. Both have a tool bar at the top of the screen that says mirror.this will flip your drawing over.
Hope this works Jim(murals in metal)


Return to “Torchmate”

Who is online

Users browsing this forum: No registered users and 2 guests

Easyscriber engrave attachment for Hypertherm torch's