Image
To close this announcement click the X in the top right corner.
Industry Pros use FastCut CNC

Torchmate Driver Keystrokes

Torchmate Hardware discussion forum
Post Reply
jpaakman
1 Star Member
1 Star Member
Posts: 21
Joined: Sat Jul 04, 2020 3:02 am

Torchmate Driver Keystrokes

Post by jpaakman » Sun Nov 22, 2020 6:00 pm

Hey guys,

I'm setting up a remote control for jogging my gantry to start position on the Torchmate Driver software. I have most everything set up and working for a usb game controller pad I purchased on Amazon.

However I was wondering if there is a Shortcut guide for some other functions like, Zero all, Aux on, Point to program zero, Fast medium and slow jog.

When I'm in the Torchmate controller software I see the pendant in the configuration. If I load "standard Layout" the program its all in there. I just need to figure out what the keystroke shortcuts are. (the pendant in the config will not work with USB controller)

Any help with finding a resource or recording the "macro". Would greatly help.


Thanks,


Jeremy

Kitch940
1 Star Member
1 Star Member
Posts: 14
Joined: Sun Feb 14, 2016 11:38 am

Re: Torchmate Driver Keystrokes

Post by Kitch940 » Tue Dec 29, 2020 10:27 am

Jeremy did you ever get your wireless remote setup working? I am using driver software version 4 and use a playstation controller to control my whole table. I can send you instructions if you need.

Dan

Post Reply

Return to “Torchmate”

Industry Pros use FastCut CNC