Easyscriber engrave attachment for Hypertherm torch's
 

Convert a 4X4 Growth series to a 4X8

Torchmate Hardware discussion forum
Post Reply
Fastyankee
Posts: 13
Joined: Sat May 20, 2017 11:30 am
Location: Fernandina Florida
Contact:

Convert a 4X4 Growth series to a 4X8

Post by Fastyankee » Sat May 20, 2017 12:29 pm

Is it possible to convert a 4X4 growth series to a 4x10. I would like to take my gantry from my 4x4 and retro fit it with gear drive and build a 10' long table for it.
I figured this is the place to start.
Should I go with a better driver system. I also have AVHC.
I'm not really happy with the Accumove I have, its very un reliable.

Thanks In advance

Code-man
Posts: 10
Joined: Wed Nov 02, 2016 9:45 pm

Re: Convert a 4X4 Growth series to a 4X8

Post by Code-man » Sat Jan 06, 2018 11:46 am

I am also wondering the same thing. I have been looking at the classic tm3 and how they have their motors mounted. Did you get anything figured out on yours?

tcaudle
Posts: 1059
Joined: Tue Feb 28, 2012 6:47 pm

Re: Convert a 4X4 Growth series to a 4X8

Post by tcaudle » Sat Jan 06, 2018 12:08 pm

Can't help much with the mechanics but for the controls (including the THC) here is a possible solution: https://www.candcnc.com/store-home/tm-rescue-kit/

Post Reply