New growth 2x4 table issues,....need help !

Torchmate Hardware discussion forum
Post Reply
poppopsworkshop
2 Star Member
2 Star Member
Posts: 51
Joined: Tue Sep 08, 2015 12:09 am

New growth 2x4 table issues,....need help !

Post by poppopsworkshop »

Having issues cutting on my new growth water table. Using accumove 2 controller and hypertherm65. When in dry run mode it travels fine. But in active run, it just pierces a hole and shuts down after 5 seconds or so. I'm also not sure I have my hypertherm65 set up correctly. any help is greatly appricated. Trying to cut 16 gauge.
madracing007
1/2 Star Member
1/2 Star Member
Posts: 4
Joined: Sat Oct 18, 2014 7:00 pm

Re: New growth 2x4 table issues,....need help !

Post by madracing007 »

do you have the raw arc voltage wire hooked up? along with the ok to move? sometimes when i forget to hook my ground to the metal it will do that maybe your not getting a good ground? in dry mode it dont look for those signals so it will just run
poppopsworkshop
2 Star Member
2 Star Member
Posts: 51
Joined: Tue Sep 08, 2015 12:09 am

Re: New growth 2x4 table issues,....need help !

Post by poppopsworkshop »

Thanks, It was a bad ground in my electrical panel.
Post Reply

Return to “Torchmate Forum”