My TM3 started acting up today....the Y axis would only jog to the +, .......even when clicking on the -. The motor went + no matter which way I told it to go. I reset the controllers, checked the wiring and it worked ok for a little bit, so I tried cutting a small piece, and about half way through, it took off the wrong way again. In the middle of cutting a hole, it took off and the cut ended up looking like an "S". So I wiggled the wires and checked everything I could think of and tried again, then when jogging the other axis that had been working ok, it started growling and stopped after moving a few inches.
Anybody have any ideas, other than the controller it toast?
Torchmate axis motor only goes +
-
Redneck
- 3 Star Member
- Posts: 273
- Joined: Sat Oct 06, 2012 7:16 pm
-
_Ogre
- 3.5 Star Member
- Posts: 529
- Joined: Sun Sep 15, 2013 4:26 pm
- Location: Motown
Re: Torchmate axis motor only goes +
tm tech support would be able to help you trouble shoot that
bulltear 4x8 cnc plasma table, candcnc bladerunner w/dthc, hypertherm powermax 65, sheetcam, mach3
laser cross hair for hypertherm torch http://www.plasmaspider.com/viewtopic.php?f=6&t=12508
an ogre smiley
how cool!
laser cross hair for hypertherm torch http://www.plasmaspider.com/viewtopic.php?f=6&t=12508
an ogre smiley
how cool!-
Redneck
- 3 Star Member
- Posts: 273
- Joined: Sat Oct 06, 2012 7:16 pm
Re: Torchmate axis motor only goes +
Yes, and they have always been very good......but they aren't there on the weekend._Ogre wrote:tm tech support would be able to help you trouble shoot that
