Torchmate 2 Blue Screen AVHC - auto mode, problems & questions.

Torchmate Hardware discussion forum
Post Reply
tac1fab
Posts: 7
Joined: Fri Nov 01, 2019 2:58 pm

Torchmate 2 Blue Screen AVHC - auto mode, problems & questions.

Post by tac1fab » Mon Oct 26, 2020 11:34 am

We've got the old blue screen torch height control.. The previous owner of table/system was never able to successfully use the AVHC in "auto" (with any consistency).. .. Therefor when we bought the table we have almost always used it in "manual mode". I've finally got time to get this thing figured out and have noticed the the AVHC is not reading voltage/well sometimes it works sometimes it's not... Is there a diagnostic or cables I should be checking for this?

I've been told these old blue screen height controls are very problematic and really didn't work well.. I've been in contact with Flashcut CNC about their retrofit kit.. but would try to get what we have working.. I know a functional auto height control will really help with cut quality and consumable life. What are your opinions? Thank you

Torchmate 2, 5x10 table, Hypertherm Powermax 85, Torchmate Plate marker.

cuttinparts
Posts: 211
Joined: Tue Sep 30, 2008 3:40 pm

Re: Torchmate 2 Blue Screen AVHC - auto mode, problems & questions.

Post by cuttinparts » Tue Oct 27, 2020 11:17 am

A friend of mine had the same ir similar setup and was never able to get the THC to work reliably and this seems to be a common issue with those older setups. I know both Flashcut and C&CNC have solutions for you but yes THC will be a HUGE benefit for you once you get something working.

tac1fab
Posts: 7
Joined: Fri Nov 01, 2019 2:58 pm

Re: Torchmate 2 Blue Screen AVHC - auto mode, problems & questions.

Post by tac1fab » Tue Oct 27, 2020 12:07 pm

Thank you! Yes, the more I research the more I'm learning the old Torchmate AVHC is pretty much worthless.

ed08
Posts: 2
Joined: Mon Aug 03, 2020 11:56 am

Re: Torchmate 2 Blue Screen AVHC - auto mode, problems & questions.

Post by ed08 » Tue Dec 21, 2021 12:15 pm

tac1fab, Did you ever resolve this or move forward with a replacement? I'm in the same boat with the blue screen AVHC on a torchmate growth series table. Tired of crashing into material and ruining cuts so starting to look more seriously at replacement options.

Thanks.

Post Reply

Return to “Torchmate”

Industry Pros use FastCut CNC