Machin control error: Torch Cutting Signal never shut off

PlasmaCam Hardware discussion forum
Post Reply
Miguel Rosas
1/2 Star Member
1/2 Star Member
Posts: 1
Joined: Wed Sep 26, 2018 4:03 pm

Machin control error: Torch Cutting Signal never shut off

Post by Miguel Rosas »

My machine is showing the following message: Torch Cutting Signal never shut off. Check wiring. Power Or turn off option.

This happens after each cut and clicking on OK allows me to continue cutting.

What's going on? because it shows this message ?.

I thank you in advance for your support
Post Reply

Return to “PlasmaCam, Samson, & Go Torch Forum”