It is currently Tue Nov 13, 2018 7:42 pm

 

Machin control error: Torch Cutting Signal never shut off

PlasmaCam Hardware discussion forum
Miguel Rosas
Posts: 1
Joined: Wed Sep 26, 2018 4:03 pm

Machin control error: Torch Cutting Signal never shut off

Postby Miguel Rosas » Sat Sep 29, 2018 3:26 pm

My machine is showing the following message: Torch Cutting Signal never shut off. Check wiring. Power Or turn off option.

This happens after each cut and clicking on OK allows me to continue cutting.

What's going on? because it shows this message ?.

I thank you in advance for your support

Return to “PlasmaCam”

Who is online

Users browsing this forum: No registered users and 3 guests

Easyscriber engrave attachment for Hypertherm torch's