DHC and GoTorch same controller?

PlasmaCam Hardware discussion forum
Post Reply
User avatar
yeomansjon
3 Star Member
3 Star Member
Posts: 329
Joined: Fri Oct 05, 2012 1:28 pm
Contact:

DHC and GoTorch same controller?

Post by yeomansjon »

Does anyone know if the Plasmacam DHC and GoTorch with Plasmacam controls uses the same controller box? My DHC control box died and until I raise a few bucks for the $7k upgrade, I wondered if a GoTorch control box would work in the interim.
Fast Jonny Custom Design
CNC Plasma Cutting
Plasmacam DHC
Hypertherm Powermax 1000
www.facebook.com/fastjonnycustomdesign
User avatar
rdj357
4 Star Elite Contributing Member
4 Star Elite Contributing Member
Posts: 1157
Joined: Sun Mar 11, 2012 4:40 pm
Location: Tahlequah, OK
Contact:

Re: DHC and GoTorch same controller?

Post by rdj357 »

Any new controller new or repaired by PC (from the last several years) will not work with the 3.11 or older software. The only option that I'm aware of other than the one you mentioned, would be to upgrade your software to Design Edge ($2k) and send your controller in for repair ($500-$700 I believe).

I'd recommend calling PlasmaCAM sales and discussing the options. Sorry that wasn't better news!
Post Reply

Return to “PlasmaCam, Samson, & Go Torch Forum”