It is currently Wed Nov 14, 2018 12:45 pm

 

DHC and GoTorch same controller?

PlasmaCam Hardware discussion forum
User avatar
yeomansjon
Elite Contributing Member
Elite Contributing Member
Posts: 334
Joined: Fri Oct 05, 2012 1:28 pm
Contact:

DHC and GoTorch same controller?

Postby yeomansjon » Sat Sep 15, 2018 8:46 am

Does anyone know if the Plasmacam DHC and GoTorch with Plasmacam controls uses the same controller box? My DHC control box died and until I raise a few bucks for the $7k upgrade, I wondered if a GoTorch control box would work in the interim.
Fast Jonny Custom Design
CNC Plasma Cutting
Plasmacam DHC
Hypertherm Powermax 1000
www.facebook.com/fastjonnycustomdesign

User avatar
rdj357
Elite Contributing Member
Elite Contributing Member
Posts: 539
Joined: Sun Mar 11, 2012 4:40 pm

Re: DHC and GoTorch same controller?

Postby rdj357 » Sat Sep 15, 2018 8:55 am

Any new controller new or repaired by PC (from the last several years) will not work with the 3.11 or older software. The only option that I'm aware of other than the one you mentioned, would be to upgrade your software to Design Edge ($2k) and send your controller in for repair ($500-$700 I believe).

I'd recommend calling PlasmaCAM sales and discussing the options. Sorry that wasn't better news!
Robert Johnson
----- PlasmaCam 5x10 Table -----
FourNinety Creations & Learn PC, LLC

Learn Plasmacam Website
Learn Plasmacam on Facebook
Learn Plasmacam on YouTube


Return to “PlasmaCam”

Who is online

Users browsing this forum: No registered users and 3 guests

Easyscriber engrave attachment for Hypertherm torch's