It is currently Fri Nov 16, 2018 3:07 am

 

newbie

PlasmaCam Hardware discussion forum
bobthewelder
Posts: 1
Joined: Wed Jun 20, 2018 5:12 pm

newbie

Postby bobthewelder » Wed Jun 20, 2018 5:35 pm

hey guys , new to the plasma table world...and the whole programming game...

I bought the piranha c510,,,seems awesome so far,,,not sure how I feel about the plasmacam software yet,,,my setup guy wasn't much help with getting me started..
one qwik question of many to start...
is there dxf downloads that are totally ready to load and cut or do I have to run them all thru the plasmacam cad clean,,,blah blah????


thanks in advance

Return to “PlasmaCam”

Who is online

Users browsing this forum: No registered users and 3 guests

Easyscriber engrave attachment for Hypertherm torch's