Easyscriber engrave attachment for Hypertherm torch's
 

4x4 to 4x8

PlasmaCam Hardware discussion forum
Post Reply
Twisted 1
Posts: 45
Joined: Thu Jan 28, 2010 9:47 am
Location: Ontario Canada

4x4 to 4x8

Post by Twisted 1 » Sun Mar 25, 2018 3:13 pm

Hi all. I know that this has been asked before but am having a hard time finding what I am looking for. I am running 3.11. To do the upgrade do I just purchase 2 rails and 1 extra gear rack. Then but up the rails and slide the rack to butt up against the one on the machine now. Then just cut the extra and put on the ends. Also if I move the boom to the center leg do I need to get longer cables. Thanks
Pete
Twisted Image Customs and Fabrication
Ontario Canada

Bobkovacs
Posts: 101
Joined: Sun Aug 18, 2013 8:47 pm

Re: 4x4 to 4x8

Post by Bobkovacs » Sun Mar 25, 2018 6:02 pm

Pretty sure they charge you to modify the software to work with the larger cutting area ($1k or $2k if I recall correctly)

User avatar
SegoMan DeSigns
Posts: 104
Joined: Sat Jan 06, 2018 4:45 pm

Re: 4x4 to 4x8

Post by SegoMan DeSigns » Sun Mar 25, 2018 8:21 pm

Use the existing machine to build a second machine, that's what I'm doing. The upgrade cost is money that was better spent building a new unit.

Twisted 1
Posts: 45
Joined: Thu Jan 28, 2010 9:47 am
Location: Ontario Canada

Re: 4x4 to 4x8

Post by Twisted 1 » Mon Mar 26, 2018 6:39 am

Would love to see some pictures of what you are building
Pete
Twisted Image Customs and Fabrication
Ontario Canada

User avatar
SegoMan DeSigns
Posts: 104
Joined: Sat Jan 06, 2018 4:45 pm

Re: 4x4 to 4x8

Post by SegoMan DeSigns » Tue Mar 27, 2018 1:40 pm

Twisted 1 wrote:Would love to see some pictures of what you are building
PM me your email addy and I'll send a few, after the project is done I'll do some vids but until then it's build time..

Post Reply