CUTTING THIN BRASS AND COPPER WITH A POWERMAX45

Hypertherm Plasma Cutter discussion forum.
Post Reply
enzed
2 Star Member
2 Star Member
Posts: 82
Joined: Mon Aug 17, 2015 1:44 pm

CUTTING THIN BRASS AND COPPER WITH A POWERMAX45

Post by enzed »

Can I cut 22 gauge (0.7 mm) brass sheet and 25 gauge (0.5 mm) copper sheet cleanly with a Powermax45? If so, at what settings?
Top
robertspark
4.5 Star Elite Contributing Member
4.5 Star Elite Contributing Member
Posts: 1814
Joined: Mon Jun 12, 2017 6:43 pm

Re: CUTTING VERY THIN MATERIAL WITH A POWERMAX45

Post by robertspark »

I don't believe you are going to get an answer on this one as few will know

here is a bit of sound advice I read years ago

viewtopic.php?f=4&t=13561&p=75102&hilit ... olt#p75102
Top
enzed
2 Star Member
2 Star Member
Posts: 82
Joined: Mon Aug 17, 2015 1:44 pm

Re: CUTTING VERY THIN MATERIAL WITH A POWERMAX45

Post by enzed »

Thanks very much Robertspark. Your references provide valuable information and confirm some of my suspicions.
Top
N2 Welding
3 Star Member
3 Star Member
Posts: 290
Joined: Sat Oct 27, 2018 2:07 pm

Re: CUTTING VERY THIN MATERIAL WITH A POWERMAX45

Post by N2 Welding »

I would never have guessed cutting copper or brass could be such a PITA.
Top
Post Reply

Return to “Hypertherm Plasma Cutters”