Any news on newer 65/85?

rbmgf7 · Post by **rbmgf7** » Wed Feb 03, 2021 10:31 am

Still choochin' on my PM45 but would like to upgrade eventually. The 65/85 have been around for quite some time but was wondering if anyone has heard anything through the grapevine on a new 65/85 release? Figure they're due after the 45XP.

Post by **adbuch** » Sun Feb 28, 2021 8:43 pm

As far a I know, the 45xp/65/85 series is the current offering from Hypertherm. I have been using the 45xp and 85 for about 4 years now with no problems, and am very happy with them.
David

cowboytex1956 · Post by **cowboytex1956** » Wed Mar 17, 2021 10:33 am

David, would you share your settings for your 85? I picked up a used one and didn’t get a owner’s manual with it. I just got the slats put in my water pan. Thanks Ernie

Post by **djreiswig** » Wed Mar 17, 2021 12:56 pm

Here is the manual.
https://www.hypertherm.com/Download?fileId=HYP115403

Post by **adbuch** » Wed Mar 17, 2021 6:55 pm

cowboytex1956 wrote: ↑Wed Mar 17, 2021 10:33 am David, would you share your settings for your 85? I picked up a used one and didn’t get a owner’s manual with it. I just got the slats put in my water pan. Thanks Ernie

The link to the Hypertherm manual was just posted above. It contains the mechanized cut charts, kerf width chart, and other useful information.
David

Any news on newer 65/85?

Any news on newer 65/85?

Re: Any news on newer 65/85?

Re: Any news on newer 65/85?

Re: Any news on newer 65/85?

Re: Any news on newer 65/85?