Machine torch disassembly

[kbdiesel]

Hey guys, how do you disassemble the machine torch to get to the upper brass parts?
I have started twisting the cover off but the brass parts and torch cable want to twist with it.

I suspect the brass consumable mount is damaged from a tip up as it's kinda cocked and I've had some torch height/voltage issues lately.

Does anyone have part numbers for the parts past the swirl ring? I suspect I'll have to order them direct from hypertherm.
The torch is a Duramax A IEC60974-7.

Thank you!

[djreiswig]

I think there are 3 screws around the outside of the brass part that you have to remove to get it apart. I've had mine apart, but it's been a while.

[kbdiesel]

I'll have to clean it good and check. Thanks for the input!

[robertspark]

https://www.google.com/url?sa=t&source= ... 2poIBbmipo

https://www.google.com/url?sa=t&source= ... TvAy66aqYR_

I don't know what machine you have.... If I did I'd post the right manual as there are slight variations in design ....

[acourtjester]

Here are some image of the torch un-assembled. this is the torch on the 65 I have

[robertspark]

Nice detail

[kbdiesel]

Thank you everybody for the help!
I'm sure this will help someone else in the future.
I believe the PN for the brass main body is: 228793.
Mine is a powermax 85. I will verify that PN before I order it.

[SegoMan DeSigns]

The 45XP, 65, 85 & 105 Duramax machine torch uses the same parts

The Number on the main body itself is 21520 (I just got a new 50' machine torch for the 6x12 build) You have to buy a kit to get it.

Here's the link to the parts breakdown:
http://www.tecno-plasma.it/it/consumabi ... mabili.pdf

Pg 5 of the document shows the main body (5) to be in a kit part # of 228716 They are $110.00 at Bakersgas