Easyscriber engrave attachment for Hypertherm torch's
 

Powermax 65 not powering on

Hypertherm Plasma Cutter discussion forum.
Post Reply
DARRYL21270
Posts: 493
Joined: Fri Jun 05, 2009 7:09 am
Location: New Jersey
Contact:

Powermax 65 not powering on

Post by DARRYL21270 » Thu Feb 08, 2018 12:56 pm

So i went to turn on my Plasma cutter this morning and have no power. I just used it a few days ago and it worked fine. I have a shut off panel with 2 70amp 250volt time delay blade fuses but no multimeter to check for current. could it be the fuses need replacing. I always leave it in the on position whether im using the cutter or not or could it be something else.

Thanks

Post Reply