It is currently Tue Oct 16, 2018 3:33 pm


Hypertherm PM 85 Full Auto Items

Hypertherm Plasma Cutter discussion forum.
Posts: 89
Joined: Fri Jan 20, 2017 3:25 am

Hypertherm PM 85 Full Auto Items

Postby tylerd » Sun Aug 27, 2017 4:06 pm

Hello, I am trying to figure out what all I need to get in order to get my PowerMax 85 connected up to my Bulltear 4x8 for fully automated cutting with Command CNC controlling all aspects of the PM 85...air voltage, etc. I am running Ethercut bladerunner with feather touch and servo's. I already have the Candcnc PWM module and cable, RS485 Hub, and the ohmic sensor module. My Hypertherm came with a 25' Hand torch, without cpc or 485 installed. This is the list of things I have come up with that I need to purchase to get up and running. Hoping someone runner similiar setup can chime in and confirm if my list is correct or i need to add or omit anything. Maybe Jim Colt will help out if he sees this. Thanks in advance to all that reply, this site awesome and I have learned a lot from it. Here is the list I have come up with:

CPC - - Part 228697

25ft Machine torch - ... ts_id=3334 - Part 059477

RS 485 Kit - Part 228539

RS-485 Cable - Part 223236

RS485 9-PIN D-SUB INTERFACE 25 - - 223239

Thanks again!
Bulltear 4x8
PN200 Pendant
Linux Command CNC
Hypertherm PM 85
C&CNC Bladerunner Servo
DTHC IV Feather Touch
HyT-Connect DCP-01
Sheetcam Inkscape QCAD

Return to “Hypertherm Plasma Cutters”

Who is online

Users browsing this forum: No registered users and 3 guests

Easyscriber engrave attachment for Hypertherm torch's