Easyscriber engrave attachment for Hypertherm torch's
 

wiring help on plasma machine torch

Hypertherm Plasma Cutter discussion forum.
Post Reply
steelhead
Posts: 5
Joined: Tue Dec 29, 2009 12:36 pm

wiring help on plasma machine torch

Post by steelhead » Thu Nov 29, 2018 6:46 pm

Does anyone know how to wire a Duramax retrofit machine torch in my older powermax 1000 that had a hand torch installed?
thank you for any help.

jimcolt
Elite Contributing Member
Elite Contributing Member
Posts: 2952
Joined: Mon Jul 20, 2009 11:18 pm
Location: New Hampshire

Re: wiring help on plasma machine torch

Post by jimcolt » Sun Dec 02, 2018 10:35 am

Instructions come with the upgrade torches. Basically you open the cover on the power supply and unplug the existing torch air and electrical connectors (no tools needed), then reverse the procedure with the new torch. There is an instruction manual included (CD) with every new Duramax torch upgrade kit.. Jim Colt Hypertherm

steelhead
Posts: 5
Joined: Tue Dec 29, 2009 12:36 pm

Re: wiring help on plasma machine torch

Post by steelhead » Mon Dec 03, 2018 10:41 am

jimcolt wrote:
Sun Dec 02, 2018 10:35 am
Instructions come with the upgrade torches. Basically you open the cover on the power supply and unplug the existing torch air and electrical connectors (no tools needed), then reverse the procedure with the new torch. There is an instruction manual included (CD) with every new Duramax torch upgrade kit.. Jim Colt Hypertherm
i wish it was that easy
had to plug 2 wires onto the board.
found an old post
ty

Post Reply