SheetCam Tool List Disappeared

[DesertFabworks]

The other day I opened up sheetcam and noticed that all of my "tools" were gone. I use it for plasma cutting and had set
tools for each type of material. Not sure where they went or how to recover them.

I found a file that looked like my saved tools but the program would not load it.

Has this happened to anyone else? anyway to recover the tools?

[FiveORacing]

I have a similar problem. I have had toolsets all disappear and had to rebuild them. A couple times. Then the other day I reopened an older file and noticed the old toolset was there and couldn't access the new one. So I think they are both there and we just need to find a way to marry them up again.

I did a little reading on it and it has to do with "Save current default tool set." If you say yes you overwrite the old one. Just a bit of confusion in the program.