Easyscriber engrave attachment for Hypertherm torch's

Air scribe offset issue

Post your questions or tips on SheetCam software in this topic.
Post Reply
Posts: 6
Joined: Tue Sep 20, 2016 6:05 pm

Air scribe offset issue

Post by Turbotweaker » Sat Sep 29, 2018 8:59 pm

I have been having an issue with Aire scribe offset when I arry multiple parts. Works just fine if you do 1 part, but if I arry the same part to make say 50 or even 2 of the same part it only offsets the original. I am stummped, works for one but not the rest it just scribes with no offset.

Thanks in advance

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest