It is currently Sun Nov 18, 2018 11:38 am


Action points

Post your questions or tips on SheetCam software in this topic.
Little Bit
Posts: 11
Joined: Thu Jul 17, 2014 7:59 am

Action points

Postby Little Bit » Thu Aug 31, 2017 8:20 pm

Hello all
I have been trying to get the action points in sheet cam to cooperate but I just dont seem to understand I lay (3) .5 Flat bar next to one another
and cut across the X axes at 6'' intervals at the seam I want to slow down slightly for .125 and then after the seam speed back up till the next seam but at the first seam it does slow down but it does not speed back up what is the significance of the shaded triangle as a posed to the un shaded triangle ? when i start code THC on or off ? do I need two triangles before the seem and another two after when I try stuff sometimes the triangles act all over the place I dont see any videos to watch Can any one shed some light on this please

Little Bit

Return to “SheetCam”

Who is online

Users browsing this forum: No registered users and 3 guests

Easyscriber engrave attachment for Hypertherm torch's