Warning during Post

Post your questions or tips on SheetCam software in this topic.
Post Reply
ironshepherdforge
Posts: 5
Joined: Mon May 04, 2020 2:09 pm

Warning during Post

Post by ironshepherdforge » Sun Sep 13, 2020 9:18 pm

I started getting this warning recently. Table still cuts, but I'd like to clear it. Can someone provide some guidance?
Sheetcam_snip.png

You do not have access to view or download this file.
Become a Contributing Member to gain access to this feature. Click Here


Les Newell
Posts: 136
Joined: Tue Mar 22, 2016 10:30 am

Re: Warning during Post

Post by Les Newell » Mon Sep 14, 2020 7:29 am

The pierce height in your tool definition is greater than the rapid clearance height (in Options->job options->material). If you increase the clearance height to be above the pierce height the warning will go away.

Les Newell
Posts: 136
Joined: Tue Mar 22, 2016 10:30 am

Re: Warning during Post

Post by Les Newell » Mon Sep 14, 2020 7:35 am

Dynatorch changed the way their machines work a few times over the years. It looks like you have an older machine. I have attached a post that should work. Open the attached zip file and save the contents to any convenient folder. Now run SheetCam and go to Options->machine->post processor. Click on the 'import post' button and open the file.
Dynatorch old.zip

You do not have access to view or download this file.
Become a Contributing Member to gain access to this feature. Click Here


User avatar
acourtjester
Elite Contributing Member
Elite Contributing Member
Posts: 4757
Joined: Sat Jun 02, 2012 6:04 pm
Location: Pensacola, Fla

Re: Warning during Post

Post by acourtjester » Mon Sep 14, 2020 9:14 am

Never a complaint about customer service with SheetCam Les to the rescue again :Like :Yay
DIY 4X4 Plasma/Router Table
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PowerTig 255 EXT

ironshepherdforge
Posts: 5
Joined: Mon May 04, 2020 2:09 pm

Re: Warning during Post

Post by ironshepherdforge » Mon Sep 14, 2020 7:05 pm

Les,

I run a Langmuir Systems Crossfire Pro. Will that dynatorch file be compatible? I'm a novice. Thank you for the quick reply.

Les Newell
Posts: 136
Joined: Tue Mar 22, 2016 10:30 am

Re: Warning during Post

Post by Les Newell » Tue Sep 15, 2020 1:17 pm

It would be best to contact Langmuir to see what post they recommend.

ironshepherdforge
Posts: 5
Joined: Mon May 04, 2020 2:09 pm

Re: Warning during Post

Post by ironshepherdforge » Tue Sep 15, 2020 10:45 pm

I ended up doing a firmware flash recommended by them which came with a different post processor. So far things are cutting well. Thanks for the support and Sheetcam...makes life so much less stressful.

Post Reply

Return to “SheetCam”

Industry Pros use FastCut CNC