4x8 AvidCNC full plasma table with legs and water tray

[plasmatik]

Hey all - had this posted previously but it got deleted. Not sure wha tI did wrong, but I had done some editing due to a pending sale so maybe I broke a rule. Anyway, here are the details again.

1 x Leg Kit (PRO CNC) (CRP813-00) = $799.00
Size 4' x 8'
1 x PRO4896 4' x 8' CNC Router Kit = $5,475.00
Version Nema 34 1/2" Shaft Compatible
Z-Axis Travel / Gantry Height 8" / 8"
Gantry Width Standard
1 x Plug and Play NEMA 34 CNC Control System (CRP800-00E-8) = $2,645.00
Additional Motor Drive None [4-Drive, Standard]
Cable configuration (1) 20' and (3) 28' cables [recommended for 4'x8' or 5'x10' machines]
1 x PRO CNC Plasma Kit = $1,100.00
Torch Height Control Plug & Play Electronics
1 x 4' x 8' PRO CNC Plasma Water Table = $1,275.00
1 x Pepperl + Fuchs Proximity Sensor Kit = $260.00
Sensor Configuration PRO CNC (machines larger than 5' x 5')
1 x Mach4 CNC Control Software = $200.00 [*]
1 x SheetCam Plasma CAM Software = $150.00 [*]

I will include the computer that has the loaded software.

I also have a Hypertherm 45xp available with the machine.

I am the first and only owner in a low volume setting.

[adbuch]

You might consider letting prospective buyers know what your asking price is, as well as your location and contact information.
David

[plasmatik]

Thanks adbuch, knew I forgot somethings....

We are in the Philadelphia area. I can be contacted by now for PM if that's OK (due to potential spam reasons). If that's not OK by forum rules, I will post an email.

We are looking for best but fair offers, and price is dependent on whether or not you want the table and hypertherm as a package or not. We would accept 11k as a package, and anything lower than that would be considered relative to other offers that come in.

[Gearhead77]

I tried to send a PM, for some reason it will not leave my outbox. Very interested in the table

[djreiswig]

I think it stays in your outbox until the receiver reads it.