Easyscriber engrave attachment for Hypertherm torch's

New tracker software

Post your questions or tips on Tracker software in this topic.
Post Reply

New tracker software

Post by Fabman » Fri Jul 22, 2011 4:19 pm

Can I use any other software for my tracker system other than cut and comand??

User avatar
Team Tracker
Posts: 103
Joined: Thu Nov 18, 2010 7:36 pm

Re: New tracker software

Post by Team Tracker » Fri Jul 22, 2011 5:31 pm

Mach 3 can be used for motion control however your automatic height control cannot be operated with Mach 3.

For what reason are you looking to change your software?

Please let me know and I will be happy to help.


Re: New tracker software

Post by Fabman » Mon Feb 24, 2014 9:16 pm

Sorry I feel like a deadbeat, never got back to see your reply. The reason I wanted to use something else was only because I was not used to it and always used post processor and g-code on my homebuilt machine. After using the cut & command software I really like it. Eliminating the post processor and g-code saves a lot of time for me and its much easier to use. Again sorry for not getting back with you.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest