Easyscriber engrave attachment for Hypertherm torch's

limit switch works on "z--" but not "z home"

Mach 3 CNC from Artsoft questions or tips can be posted to this forum.
Post Reply
Posts: 3
Joined: Sun Feb 04, 2018 2:37 pm

limit switch works on "z--" but not "z home"

Post by jaker2 » Thu Aug 30, 2018 6:58 pm

Is there an obvious reason that mach3 recognizes when my floating z limit switch will trigger under "z--" port 1, pin 13 but not when i set it as "z home" port 1, pin 13?
Cheers, Brad

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests