Page 1 of 1

Dashed rectangle in table display

Posted: Sat Jan 13, 2018 8:28 pm
by djreiswig
Can anybody tell me what the dashed rectangle means and why it suddenly appeared.l? I have another profile for flame cutting and it isn't there. I've compared settings and can't tell what could be different or why it changed. It was just there one day. It doesn't seem to hurt anything. Just wondering what happened.

Re: Dashed rectangle in table display

Posted: Sun Jan 28, 2018 2:44 pm
by djreiswig
Just in case anybody finds this post later. Somehow we inadvertently clicked the display mode button. Clicking it again and then Regen toolpath put everything back to normal.