table display problem

Post by **kbenz** » Tue Sep 08, 2015 8:29 pm

I'm getting a grey screen on my table display. If I click on it it will flash the part but that is it. been doing this since I reloaded mach. I am using the version luke from CandCNC told me to use.

Post by **Mtw fdu** » Thu Sep 10, 2015 7:17 am

I remember that happening to me as well.

I went and did "on purpose" to see what I did and how to get it off.

If you go into Mach 3 on the diagnostic page and click on toolpath on/off. It should turn off. The box next to the toolpath on/off should be green.

Hope this helps.

Mtw fdu.

Post by **acourtjester** » Thu Sep 10, 2015 8:09 am

If you go to the config drop down and then click on tool path it will bring up a menu you can change many things in the display. I like to click off machine boundaries so the part always show as full screen. I also like a black background you can change any of the colors there too

Post by **kbenz** » Fri Sep 11, 2015 10:31 am

Got it

table display problem

table display problem

Re: table display problem

Re: table display problem

Re: table display problem