It is currently Wed Nov 21, 2018 7:12 am

Easyscriber engrave attachment for Hypertherm torch's

Which codes for Proma THC ???

Mach 3 CNC from Artsoft questions or tips can be posted to this forum.
Posts: 3
Joined: Thu May 21, 2015 4:20 pm

Which codes for Proma THC ???

Postby FelixM5 » Thu May 21, 2015 4:29 pm

Hi there,
i have a 2000x1000mm plasma table working with PMX85 and machine torch.
I used to work with the processor "Mach2 plasma no z" and the standard sheetcam with Proma THC...worked fine

I wanted to use the path rules and pierce height, so I just upgraded to sheetcam TNG and now using the post processor "Mach3 plasma THC with scriber and backlash compensation"
Does anyone know how to setup the Proma THC ? Which codes to use?
Everything is working, but the Z-axis is fixed to the values entered in sheetcam plasma tool.

With best Regards

Posts: 1051
Joined: Tue Feb 28, 2012 6:47 pm

Re: Which codes for Proma THC ???

Postby tcaudle » Thu May 21, 2015 6:53 pm

Not aware of any codes that could be used with Proma THC. There is no conversation between the Proma and MACH other than the UP and Down inputs
Any special codes from SheetCAM have to be decoded by a custom application (plugin) in MACH. There are no plugins for that product.

User avatar
Elite Contributing Member
Elite Contributing Member
Posts: 3223
Joined: Sat Jun 02, 2012 6:04 pm
Location: Pensacola, Fla

Re: Which codes for Proma THC ???

Postby acourtjester » Thu May 21, 2015 7:33 pm

I did not use any special codes for Proma but you must turn on the THC on the program page of mach for it to work.
see attached image
the signal for the proma are inputted to Mach like limit switch inputs they need to be ID in the port and pins page scroll down and you will see THC up, down and arc OK . You can run the proma in test mode and see the light on the diagnostic page for arc on Torch up and down is the are working.

You do not have access to download this dxf file.
Become a Contributing Member to gain access to the thousands of files shared by our members. Click Here

DIY 4X4 Plasma/Router Table
CandCNC DTHC-IV & Feather Touch
Hypertherm PM65 Machine Torch
Drag Knife and Scribe
Miller Mig welder
13" metal lathe
Small Mill
Everlast PM 256 tig

Posts: 3
Joined: Thu May 21, 2015 4:20 pm

Re: Which codes for Proma THC ???

Postby FelixM5 » Sun May 24, 2015 9:39 am

...found the mistake.
My friend was the last one working on the machine and I told him not to forget to switch "everything" Off.
So he switched the PMX, the computer .....and the hardware switch for THC on the table in Off.
Now the switch is marked to keep in ON :lol:

Thanks for your help

Return to “Mach3 CNC”

Who is online

Users browsing this forum: No registered users and 1 guest

Easyscriber engrave attachment for Hypertherm torch's