Easyscriber engrave attachment for Hypertherm torch's

DHC Software ?

Post your questions or tips on Plasmacam software in this topic.
Post Reply
Posts: 1
Joined: Tue Oct 18, 2016 7:42 pm

DHC Software ?

Post by steveb3906 » Tue Oct 18, 2016 8:12 pm

I recently bought a used Plasmacam DHC setup. Working well before moving to my shop.

After the move, the computer hard drive went bad, no recovery on it. I believe it was running 3.11 software. naturally no disk or backup :(

My question is does the new DesignEdge software run the DHC version controller/table ? Or is it only for the DHC2 controller/table ?



Posts: 112
Joined: Mon Nov 10, 2014 10:55 am

Re: DHC Software ?

Post by PlasmaMac » Thu Oct 20, 2016 2:28 pm

The designedge upgrade can go on a dhc machine. Another thing to consider is the upgrade kit that plasmacam recently made available that would essentially convert your older DHC system in a New Dhc2. That upgrade kit will also come with the designedge upgrade at a discounted price.

Best thing to do would be to call in and talk to one of the guys in there.


Post Reply