It is currently Tue Oct 16, 2018 7:26 pm


DHC Software ?

Post your questions or tips on Plasmacam software in this topic.
Posts: 1
Joined: Tue Oct 18, 2016 7:42 pm

DHC Software ?

Postby steveb3906 » Tue Oct 18, 2016 8:12 pm

I recently bought a used Plasmacam DHC setup. Working well before moving to my shop.

After the move, the computer hard drive went bad, no recovery on it. I believe it was running 3.11 software. naturally no disk or backup :(

My question is does the new DesignEdge software run the DHC version controller/table ? Or is it only for the DHC2 controller/table ?



Posts: 112
Joined: Mon Nov 10, 2014 10:55 am

Re: DHC Software ?

Postby PlasmaMac » Thu Oct 20, 2016 2:28 pm

The designedge upgrade can go on a dhc machine. Another thing to consider is the upgrade kit that plasmacam recently made available that would essentially convert your older DHC system in a New Dhc2. That upgrade kit will also come with the designedge upgrade at a discounted price.

Best thing to do would be to call in and talk to one of the guys in there.


Return to “Plasmacam Software”

Who is online

Users browsing this forum: No registered users and 1 guest

Easyscriber engrave attachment for Hypertherm torch's