It is currently Wed Nov 14, 2018 11:57 pm


Cut Path Setup

Post your questions or tips on Plasmacam software in this topic.
User avatar
Elite Contributing Member
Elite Contributing Member
Posts: 334
Joined: Fri Oct 05, 2012 1:28 pm

Cut Path Setup

Postby yeomansjon » Thu May 22, 2014 12:37 pm

I am using the older Plasmacam DHC design software (not the updated design edge) and I am having an issue where my cut wants to start at the opposite end of a line from where I click to start it. This seems to be a new problem. I get this whether I have 'snap' on or off. So to setup my file, I have to go around selecting the opposite end of all my cuts. It starts correctly with hole conversions, unless I re-link those lines and have to click the cut path all over again in which case it does the same. Anyone know if there was a setting or something I may have bumped by accident? I can't seem to figure out what would cause this. Any help is appreciated. Thank you.
Fast Jonny Custom Design
CNC Plasma Cutting
Plasmacam DHC
Hypertherm Powermax 1000

Return to “Plasmacam Software”

Who is online

Users browsing this forum: No registered users and 1 guest

Easyscriber engrave attachment for Hypertherm torch's