It is currently Sat Oct 20, 2018 9:08 am

 

98z software

Post your questions or tips on Plasmacam software in this topic.
Heritageironmn
Posts: 10
Joined: Fri Apr 25, 2014 12:27 am

98z software

Postby Heritageironmn » Tue May 13, 2014 11:02 am

Just bought an 98z as an entry level machine with minimum investment.
It came with Plasmacam 1.2 software.
Are their upgrades to this software that would compatable?
If so where would a person get the upgrades?
I realize the obvious answer is to go with a new table and Design Edge.
However, you gotta crawl before ya run, so to speak!

Thank you in advance
HeritageIronMN

drakus
Posts: 83
Joined: Sat Nov 17, 2012 1:58 pm
Location: Valparaiso, IN

Re: 98z software

Postby drakus » Tue May 13, 2014 12:45 pm

Contact plasmacam direct. It will probably cost you some $$$. I do doubt there is any upgrades to it since it is one of their original models.
--------------------------------------------------
Ted
Pcam DHC2 with the works
PM 30, 45 & 65
Corel Draw X6 - Adobe CS5

User avatar
BrianMick
Elite Contributing Member
Elite Contributing Member
Posts: 1017
Joined: Sun Dec 06, 2009 8:00 am
Location: St. Cloud,Minnesota United States of America
Contact:

Re: 98z software

Postby BrianMick » Tue May 13, 2014 5:33 pm

sup Brian, You ever need any more help just ask
Brian

Metalfx
Posts: 2
Joined: Thu Nov 23, 2017 8:24 pm

Re: 98z software

Postby Metalfx » Fri Nov 24, 2017 3:20 pm

I'm looking for 1.2 software. Do you still have it?


Return to “Plasmacam Software”

Who is online

Users browsing this forum: No registered users and 3 guests

Easyscriber engrave attachment for Hypertherm torch's