Torch does not pierce when it should on TM-2

Torchmates software related questions and tips can be posted here
Post Reply
inspectweld
2 Star Member
2 Star Member
Posts: 60
Joined: Tue Dec 26, 2017 10:11 pm

Torch does not pierce when it should on TM-2

Post by inspectweld »

I just changed computers and re loaded the TM-2 software. I tried to run a program and everything is fine except the torch goes down and senses the plate but does not fire then travels the tool path about 2 inches and then starts to fire. Does anyone know where and what setting I need to change to correct this? Thanks
inspectweld
2 Star Member
2 Star Member
Posts: 60
Joined: Tue Dec 26, 2017 10:11 pm

Re: Torch does not pierce when it should on TM-2

Post by inspectweld »

Got it going, set m50 at 3, works fine at that thickness.
plasmanewbie
4.5 Star Elite Contributing Member
4.5 Star Elite Contributing Member
Posts: 2565
Joined: Thu Jul 24, 2008 11:15 am

Re: Torch does not pierce when it should on TM-2

Post by plasmanewbie »

Thanks for posting the solution :Like
Post Reply

Return to “Torchmate Software”